Appendix A. Rack Installation Instructions - IBM Netfinity 6000R User Reference Manual

3
A
Use the tab on the rear of the slide rail to
A
align the slide rail to the rack. If it is necessary
to adjust the slide rail, loosen the screws
the rear of the rail.
5
C
B
Use the hinge pin to attach the
A
cable-management arm
Note: If you need to access the rear of the
server, rotate the lever
and pull the arm away from the server.
Otherwise, the lever must be in the horizontal
position inside the rack to prevent the cables
from touching the rear door of the rack.
B
on
B
A
to the hinge bracket.
B
to the vertical position
C
4
Use the M6 screws to bolt the slide rail to the
front of the rack (left front of rack
Then, use the M6 screws to b
rail and the hinge bracket on the right rear of
the rack. If you loosened the screws at the
rear of the slide rail, tighten them now. Repeat
the slide-rail-installation instructions for the
other slide rail.
6
A
Caution: To avoid injury, do not place your
fingers around the rack-support wheels
when lowering the server onto the rails.
Fully extend the slide rails out of the rack. Lift
the server above the rails; then, rest the rack-
support wheels on the slide rails.
A

Appendix A. Rack installation instructions

shown here).
olt the slide
A
A
181