Serverguide Error Symptoms - IBM Netfinity 6000R User Reference Manual

POST message
00181000 PCI error.
Action:
If the problem persists, call for service.
01295085 The ECC checking hardware test failed.
Action:
01298001 No update data is available for processor 1.
Action:
01298002 No update data is available for processor 2.
Action:
01298101 The update data for processor 1 is incorrect.
Action:
01298102 The update data for processor 2 is incorrect.
Action:
01298200 Microprocessor speed mismatch
Action:
I9990301 A hard disk drive error occurred.
Action:
I9990305 POST could not find an operating system.
Action:
If you cannot reinstall the operating system, call for service.
I9990650 AC power has been restored.
Action:
Other Numbers POST found an error.
Action:
Table 18. POST error messages

ServerGuide error symptoms

Look for the symptom in the left column of the chart. Probable solutions to the
problem are in the right column.
Remove the PCI adapters. If you can start the server without the adapters,
reinstall each adapter one at a time and retest after each is reinstalled.
When an adapter fails, replace it.
Call for service.
Update the system BIOS to a level that supports the microprocessors
installed in the server.
Update the system BIOS to a level that supports the microprocessors
installed in the server.
Update the system BIOS to a level that supports the microprocessors
installed in the server.
Update the system BIOS to a level that supports the microprocessors
installed in the server.
The microprocessors installed do not run at the same speed; install
microprocessors with identical speeds.
Call for service.
Install an operating system. If you have already installed the operating
system, check the drive startup sequence. If the drive sequence is correct,
run the diagnostic tests to verify that the hard disk drive is functioning
correctly. If there is a problem with the hard disk drive (such as a bad
sector), you might need to reinstall the operating system.
No action is required. This message appears each time AC power is
restored to the server after an AC power loss.
Follow the instructions on the screen.
Description
Chapter 7. Solving problems
131