Electrical Connection - Kenmore Elite HE4 110.8508 Series Use & Care Manual

Slytp 2: Direct wire strain relief
• l.hscrew the removable retaining
mn
'1','
a (1.9 cm) UL listed strain relief (UL marking on
s:rain relief). Put the threaded
t:>rough the hole below the temninal block opening.
Reaching inside the terminal block opening, screw the
rerTl:)vable retaining nut onto the strain relief threads.
A.
Removable
B. Strain relilJf threads
• Put power supply cable through the strain relief. The
strain relief should have a tight frt wrth the dryer cabinet
and be in a horizontal position. Tighten strain relief screw
against the power supply cable.
4. Now complete Installation following instnuctions for your type
connection~
of electrical
4-wire (recommended)
[If
3.wire 4-wire is not available)
nut and any
section of the strain relief
A
/
\
;:
B
retaining nut
•
,
Electrical
screws
If your home has:
receptacle
4-Wlre
(NEMA Type 14-30R)
(Q)
4-wire direct
~J..~
3-wire receptacle
(NEMA type 10-30R)
~
3-Mre
direct
mme~~
-If local codes do not permit the connection
grounding
3-wire connection"
4-wire connection: Power supply cord
IMPORTANT: A 4-wlre connection
and where local codes do not permit the use of
connections.
'~~
WeD
Connection Oplions
And you will be
connecting to:
A UL listed.
120/240 volt
minimum,
30 amp. dryer
power supply
cord.
A fused
disconnect
circuit breaker
box'
A UL I,sted.
120/240 volt
minimum,
30 amp. dryer
power supply
cord.
A fused
disconnect
circuit breaker
box .
conductor to the neutral wire. go to "Optional
section.
IS required for mobile homes
,~~
E
A. 4-wire receptacle (NEMA rype f4-30R)
B 4.prong pfug
C.
Ground prong
D.
N9Utral prong
E.
Spade
termina's with uptumed
F ~.
gem)
(7.
UL listed strain relief
G.
Ring terminals
Go 10 Seclion
4-wlre connection:
Power supply cord
4-wire connection:
or Direct Wire
3-wire connection:
Power supply cord
3-wire
connectIon:
Wire
Direct
or
of a frame-
3-wire
G
ends