Kenmore Elite HE4 110.8508 Series Use & Care Manual page 17

4. Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the last screw from Step 2
Remove the 6 screws to release the outer door assembly
from the inner door assembly, as indicated below. See
illustration. It is important that you remove only the
6 indicated screws.
5. Lift the inner door assembly off 01 the outer door assembly.
Set the outer door assembly aside.
Reverse the hinge and hinge cover
1. Place the inner door, screw head side up, on the wor1<space.
2. Gently pull the plasllc cover out and down. This unsnaps the
plastic hinge cover from the inside door assembly.
3. Remove the 4 screws that hold the hinge to the door.
4. Move the 2 large hole screw plugs to the opposite side and
insert in the original screw holes.
A
5. Move hinge to the other side and reattach with the 4 screws
removed in Step 3.
6. Reverse the plastic cover. Slide
assembly edge and gently snap into place.
7. Set the inner door assembly aside.
Reverse the door handle
1. Place the outer door assembly lace down on wor1<space.
.2. Remove the 2 screws that hold the door handle and the
2 screws holding the hole plugs. It hole plugs do not easily fall
out after screws are removed. insert a small screwdriver into
the holes and gently push the plugs out.
3. Move the door handle to the other side and reattach with the
2 screws removed from the door handle in Step 2.
4. Move the hole plugs to the new hinge side and attach with
the 2 screws removed trom the hole plugs in Step 2.
A. Hinge SCllfWS
B. Hole SCI'tlW plugs
it
up over the inner door
-
A~~_____
,
"
/
\
,---------""
A. Door h8ndle
B. Hole plugs
.
B
,
"
\
1
I
I
I
I