Electrical Requirements - Kenmore Elite HE4 110.8508 Series Use & Care Manual

Closet installation - Dryer only
10-:' 0"1
31l\"~
(0 (SO c:m) (0 om)
<Ill)
A
A Side view - closet or confined 8rae
B. Closet door with vents
Recessed or closet installation
00
O"~ 27" •
(0 om) (68.6 om)
A
A. Recessed
B. Side view - closet or confined area
Mobile home. additional
This dryer is su~able for mobile home installations.
The installation must conform to the Manufactured
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, rrtle 24, HUD Part 280).
Mobile home installations
• Metal exhaust system hardware which is available for
purchase from your local Sears store or Sears Service Center.
• Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
j
cain..'
<m~
(310
2. tn.'
(lS5cm~
1"
B
- Dryer on pedestal
o
I"
I o-~ 0"1
o'
311'" ~
(0 om) (0 om) (80 om) (0 om)
B
8ra8
installation requirements
Home
require:
3"
(7.6 om)
It is your responsibility
• To contact a qualified electrical installer.
• To be sure that the electrical connection
conformance
70-latest edrtion and all local codes and ordinances.
The National Electric Code requires a 4-wire supply
connection for homes bum after 1996, dryer circuits involved
in remodeling after 1996, and all mobile home installations.
3"
A copy of the above code standards can be obtained from:
(7.6 om)
National Fire Protection Association, One Batterymarch Parl<,
Quincy, MA 02269.
• To supply the required 3 or 4 wire, single phase, 120/240-volt,
6O-Hz., AC-only electrical supply (or 3 or 4 wire, 120/208-volt
electrical supply, if specified on the seriaVrating plate) on a
separate 30-amp circuit, fused on both sides of the line. A
time-delay fuse or Circuit breaker is recommended.
to an individual branch circuit. Do not have a fuse in the
neutral or grounding circuit.
• Do not use an extension cord.
• If codes permit and a separate ground wire is used, ~ is
recommended
ground path is adequate.
Electrical
To properly install your dryer, you must determine the type of
electrical connection you will be using and follow the instructions
provided for rt here.
• This dryer is manufactured
electrical supply connection.
conductor is permanently connected to the neutral conductor
(white wire) within the dryer. If the dryer is installed with a
4-wire electrical supply connection, the green cabinet-
grounding conductor
ground conductor screw (green screw), and secured under
"the neutral terminal (center or white wire) of the terminal
block. When the green cabinet-grounding
secured under the neutral terminal (center or white wire) of
the terminal block, the dryer cabinet is isolated from the
neutral conductor.
• If local codes do not permrt the connection of a cabinet
ground conductor to the neutral wire, see "Optional 3-wire
connection"
• Use a 4-wire conductor cord when the dryer is installed in a
mobile home or an area where local codes do not permit
grounding through the neutral.

Electrical Requirements

with the National Electrical Code, ANSI/NFPA
that a qualified electrician determine that the
Connection
ready to install with a 3-wire
The green cabinet-grounding
must be removed from the extemal
section.
__ --
-~
is adequate and in
Connect
conductor is