Venting Requirements - Kenmore Elite HE4 110.8508 Series Use & Care Manual

2. Place the hooked end of the neutral wire (white or center wire)
of power supply cable under the center screw of terminal
block (hook facing right). Squeeze hooked end together.
Tighten screw.
A~
•
B
A. External ground conductor
B. Neutral grounding
C. Center silver-eo/ored
D. Neutral wire (white or center wire)
E. ~. (1.9 em) UL listed strain relief
3. Place the hooked ends of the other power supply cable wires
under the outer terminal block screws (hooks facing right).
Squeeze hooked ends together. Tighten screws.
4. Tighten strain relief screw,
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down
Optional 3-wire connection
Use lor direct wire or power supply cord where local codes
do not permit connecting
neutral wire.
1. Remove center terminal block screw.
2. Remove neutral grounding wire (green with yellow stripes)
from external ground conductor
ground wire and the neutral wire (white or center wire) of
power supply cord/cable
block screw. Tighten screw.
3. Connect the other wires to outer terminal block screws.
Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down
screw
wire (green with yellow stripes)
terminal block screw
• •
screw.
cabinet-ground conductor
screw. Connect appliance
under center. silver.colored terminal
• •
screw,
6. Connect a separate copper ground wire from the external
ground conductor screw to an adequate ground.
c
o
A.
External ground conductor
B. Neutral groundmg wire (green with yellow stripes)
C. Neutral wire (white or center wire)
D. Grounding path determined
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal loll vent.
Failure to lollow
to
or lire.
WARNING:
EXHAUSTED OUTDOORS.
4' (10.2 em) heavy metal exhaust
DURASAFE'M venting products are recommended
available from your local Sears store or Sears Service Center.
DURASAFE'M vent ~',oducts can be purchased from your dealer.
For further information, please call1-800-4-MY-HOME''
(1-800-469-4663)
• The dryer exhaust must not be connected into any gas
chimney, wall, ceiling, or a concealed space of a building.
• Do not use an exhaust hood with a magnetic latch.
• Do not install flexible metal
floors.
• Use clamps to seal all joints. Exhaust vent must not be
connected or secured with screws or other fastening devices
that extend into the interior of the duct. Do not use duct tape.
screw
by qualifted electrician
8

Venting Requirements

AWARNING
Fire Hazard
these instructions can result in death
To reduce the risk of fire. this dryer MUST BE
vent
and clamps must be used.
or visit our Internet site at:
vent
in enclosed walls. ceilings or
and are
www.sears.com.
vent.