Embraer EMB-505 Phenom Service Manual page 177

(a) Make sure that the hydraulic fluid used in the servicing procedure
meets the specification described above and is of the same brand as
that already in the system.
(b) Use a coupling assembly (dash 4) to the suction refill hose.
(c) Remove the suction refill quick-disconnect cap.
(d) Install the auxiliary hose of the hydraulic reservoir servicing unit to the
suction refill quick-disconnect.
(e) Operate the hand pump with an approved hydraulic fluid until the reser-
voir level indicator shows full.
NOTE:Make sure that the hydraulic reservoir service unit is filled
(f) Remove the auxiliary hose from the suction refill quick-disconnect.
(g) Install the cap on suction refill quick-disconnect.
(14)Remove from the work area all tools, equipment, and materials that you
used.
EFFECTIVITY: ALL
Copyright © by EMBRAER S.A - All rights reserved - See title page for details.
with sufficient hydraulic fluid to replenish the aircraft
hydraulic fluid reservoirs. If not, air could go into the
hydraulic system.
GROUND HANDLING AND
SERVICING HANDBOOK
29-10-00-910-802-A/200
Rev.10 - AUG 27/10
Page 203