Embraer EMB-505 Phenom Service Manual page 119

NOTE: • We recommend that you apply a corrosion inhibitor to metal
surfaces independently of the cleaning material that you use.
Metal surfaces are normally treated or anodized to prevent
corrosion. Normal wear and abnormal abuse cause corro-
sion, and it is always a factor that you must consider.
• Do not scour or abrade surfaces. Corrosion protection is nor-
mally a thin layer of anodizing or organic agent. Abrasion can
remove the protective film or coating.
• Do not permit solvent to evaporate on the surface.
• Do not use a cloth a second time because this can redeposit
contaminants on the surface.
(a) Dampen a clean dry cotton cloth with the solvent. Pour the solvent on
the cloth.
(b) Wipe the metal surfaces with the solvent. Repeat the applications as
necessary to remove all dirt.
NOTE: For oxidation, powdery white corrosion, use corrosion
(c) Dry the parts with a clean, dry cotton cloth.
CAUTION: DO NOT USE BRULIN 815MX CLEANER UNDILUTED.
SOLUTIONS STRONGER THAN SPECIFIED CAN DAMAGE
THE DECORATIVE SURFACES.
(2) Use BRULIN 815MX:
NOTE: Cool water works best with normal dirt and dust. Warm water
works better with oily surfaces.
(a) Prepare a solution of BRULIN 815MX with cool or lukewarm water
between 32° C - 49° C (90° F - 120° F). Prepare a solution with 1 part
BRULIN 815MX to 64 parts of water by volume, for light dirt. You can
increase the solution up to 1 part of BRULIN 815MX to 10 parts of
water by volume.
(b) Apply the solution with a spray bottle, soft-bristle brush, sponge or cot-
ton cloth.
(c) Rub the surface with a wet sponge or cotton cloth. You can also spray
the material on the surfaces and rub with a clean sponge or soft-bristle
brush. Do not permit excess to run off to adjacent surfaces.
(d) Rub the dirty areas as necessary and repeat the application of the
solution to remove contamination.
(e) Rinse the surface with a fresh sponge or a cloth dampened with clean
water to remove residue.
(f) Dry the surface with a clean, dry cotton cloth.
EFFECTIVITY: ALL
Copyright © by EMBRAER S.A - All rights reserved - See title page for details.
inhibitor/cleaner.
GROUND HANDLING AND
SERVICING HANDBOOK
12-23-00-100-802-A/300
Page 311
NOV 20/09