Embraer EMB-505 Phenom Service Manual page 116

NOTE: Do not walk on moist areas of the carpet.
(3) Remove the wool and sink spot as follows:
CAUTION: FOR SILK CLEANING, AVOID USING WATER AND
(a) Beverage:
NOTE: Do not use metal bristles.
1. Use a dry cloth towel to blot the spot.
2. Apply pressure moderately. If the spot continues, use club soda to
make the area moist.
3. Blot until the spot is removed.
4. Use the CAPTURE to remove residual discoloration.
NOTE: Use the manufacturer's instructions.
(b) Food spill:
1. Remove as solid matter as possible.
2. Blot up as liquid matter as possible.
3. For a wool spot, use a shop wipe soaked in club soda to make the
area moist and blot up again.
4. Use CAPTURE for water based residual.
CAUTION: DO NOT OVER-SPRAY THE CARPET. APPLY ZEP-X-
5. Use Zep-X-out II for grease or oil.
NOTE: Use the manufacture's instructions.
(c) Spill in the lavatory:
1. Blot the area immediately
2. Use a shop wipe soaked in club soda, and blot again.
NOTE: • Use a tea spoon of white vinegar per 170 g (6 oz) club
3. After the area is clean, use club soda and vinegar solution to blot
again.
(d) Grease, Oil, Tar or Asphalt:
1. Remove as much as possible but do not push it deeper into the pile
or you will increase the spot.
2. Apply 1:1:1 of trichloroethane volatile dry cleaning solvent to a
clean dry towel.
3. Rub the towel on the spot with a soft circular motion.
EFFECTIVITY: ALL
Copyright © by EMBRAER S.A - All rights reserved - See title page for details.
WATER-BASED CLEANERS. USE DRY CLEANING
AGENTS ONLY.
OUT TO THE TOWEL THEN GENTLY WORK INTO
CARPET.
soda.
• Do not use vinegar rinse on silk carpet.
GROUND HANDLING AND
SERVICING HANDBOOK
12-23-00-100-802-A/300
Page 308
NOV 20/09