Firmware Update - SMA SUNNY ISLAND 4548-US Operating Manual

Off-grid inverter
Hide thumbs Also See for SUNNY ISLAND 4548-US:
Table of Contents

Advertisement

11  Data Storage on SD Memory Card

11.6 Firmware Update

The firmware of the Sunny Island can be updated via the SD memory card. Upon startup or when the
SD memory card is inserted, the Sunny Island searches for special update files on the SD memory
card. If it finds files containing new firmware versions, it performs an update when the Sunny Island is
in standby mode.
Duration of the firmware update
The update for single-phase systems takes approximately five minutes.
For system configurations with more than one Sunny Island, the software update can take up to
20 minutes.
A status bar shows the progress of the update. Leave the SD memory card in the Sunny Island
until the update is finished. During the update process, leave the DC switch to the "On" position.
Proceed as follows for a firmware update:
Observe the following:
• You may only download firmware versions from www.SMA-America.com. Using
unauthorized firmware versions cancels the warranty.
• None of the already existing parameter settings are changed or erased during a firmware
update.
• New parameters are assumed with default values.
• If there is an update to the firmware version greater or equal to 6.000, the battery
management is automatically reset. All set parameters are lost.
• Do not activate the DC circuit breaker during the firmware update.
• Do not switch off the Sunny Island during the firmware update.
1. Create a backup copy of the existing parameter lists (see Section 11.3 "Saving and Loading
Parameters", page 98).
2. Download the latest firmware version from the Internet at www.SMA-America.com.
3. Copy the "UPDATE.BIN" file to the SD memory card.
4. Set the master device to standby.
5. Insert the SD memory card into the slot of the master.
☑ The update will be performed.
Reset after a successful update
After the update has been successfully completed a reset is enforced in order for the changes
to become effective. After the reset, the master device remains in standby mode.
6. Press and hold <ENTER>.
☑ The Sunny Island starts. The update has been completed.
100
SI4548-6048-US-BE-en-21
SMA Solar Technology America LLC
Operating Manual

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Sunny island 6048-usSunny island 4548-us-10

Table of Contents