Table of Contents
Advertisement
Barcode Errors
(From page 188.)
•
Enable. An error message will print when invalid bar code data is
encountered.
•
Disable. VGL will not print an error for illegal bar code data; the bar code
will be skipped.
NOTE: When Barcode Errors is disabled, the VGL emulation will try to make
the best use of invalid data by either truncating extra digits or adding
zeros to the end of bar code data to meet minimum data length
requirements for some bar codes. Not all errors will be corrected.
The factory default is Enable.
Barcode var.
(From page 189.) This command only applies for IBARC barcode command
format.
•
Low Resolution. Sets barcode ratio dot values to be interpreted as line
matrix printer dots (60 x72).
•
High Resolution. Sets barcode ratio dot values to be interpreted as print
engine dots (300 x 300 or 203 x 203).
The factory default is Low Resolution.
Bold
(From page 191, page 194, page 196, page 198, page 200.)
•
Disable. Text is printed normally.
•
Enable. Text is printed with a heavy line thickness.
The factory default is Disable.
Bottom Margin
(From page 191, page 193, page 195, page 197, page 200.)
Defined in linespaces, starting from line zero at the bottom of the page and
incrementing from the bottom up.
The range is 0-451 linespaces, and the factory default is 0 linespaces.
Btm Margin Ctl
(From page 187.) Determines the page's bottom margin. If this option is set to
VGL Text Length, then text length changes the bottom margin value in the
LP+ Emulation submenu as follows: bottom = physical page length-top
margin-text length. If the option is set to LP+ Menu, then a change in text
length has no effect, and the bottom margin setting in the LP+ Emulation
menu will be used, although the new text length value still shows in the menu.
The options are LP+ Menu (the factory default) and VGL Text Length.
Emulation Submenus
Overview
205
Advertisement
Table of Contents
