Table of Contents
Advertisement
Host Interface
This option allows you to send print jobs through any interface with auto-
switching selected as host interface. It also allows a particular interface from
the menu to be selected.
The options are Auto Switching, Centronics, Serial, IEEE 1284, Twinax,
Coax, Ethernet and USB.
NOTE: The Twinax and Coax options appear only if the CT emulation is
installed. The Ethernet option appears only if Ethernet is installed.
The Centronics and IEEE 1284 options do not appear if Ethernet is
installed.
The factory default is Auto Switching.
Active IGP Emul
This function allows you to activate any resident IGP emulation listed in the
menu. The number of IGP emulations available is based on the Security Key
installed. The default is IGP/PGL.
There are two methods for selecting the desired emulation:
•
Select the emulation under the Active IGP Emulation menu option and
save it as Power-up Config.
•
Send a host command to switch the emulation automatically (see the
appropriate Programmer's Reference Manual for details).
Power Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode.
Pressing any key removes the power saver message from the control panel.
Sending a print job to the printer also turns off power saver mode.
The options are 1, 5, 10, 15, 30, 45, 60, and 240 minutes.
The factory default is 15 minutes.
Pwr Save Control
Pwr Save Control allows you to enable and disable Power Saver mode. If
enabled, the menu for Power Saver Time is in effect.
The options are Enable (the factory default) and Disable.
Display Language
This parameter chooses the language that will appear on the LCD: English,
German, French, Italian, Spanish, or Portuguese.
The factory default is English.
Del Char frm Fls
This option deletes downloaded character(s) from flash memory.
PRINTER CONTROL Submenus
155
Advertisement
Table of Contents
