Table of Contents
Advertisement
Ribbon Low
When eanbled and the amount of ribbon remaining on the supply spindle is
approximately 75 to 50 meters or less, the Online status indicator flashes and
"Ribbon Low" displays on the second line of the LCD. A Ribbon Low warning
message will not prevent printing.
The options are Disable (the factory default) and Enable.
NOTE: The Display Ribbon option must be set to Enable for the warning to
display.
Rbn Takeup Full
This enables or disables a fault message to display for a Ribbon Takeup Full
condition.
The options are Enable (the factory default) and Disable.
Units
This item selects either millimeters or inches as the unit of measure.
The options are In Inches (the factory default) and In Millimeters.
Set Label Length
This feature selects whether the Sensed Distance value derived from an Auto
or Manual Calibrate will be used to set the Label Length value in the MEDIA
CONTROL menu (and the QUICK SETUP menu).
•
Manual: The Sensed Distance value derived from an Auto or Manual
Calibrate will not override or change the Label Length value.
•
Automatic: When an Auto or Manual Calibrate is performed, the Sensed
Distance value derived from either calibrate will override and change the
Label Length value. If no Auto or Manual Calibrate is performed, the
current Label Length value will be used.
The factory default is Manual.
NOTE: When Set Label Length = Automatic and Gap/Mark Sensor = Gap,
Advanced Gap, or Advanced Notch, the printer will subtract the
Gap Length value (in the CALIBRATE CTRL menu) from the Sensed
Distance value obtained when the Auto or Manual Calibrate was
performed.
MEDIA CONTROL Submenus
141
Advertisement
Table of Contents
