Table of Contents
Advertisement
Form Width (char.)
(From page 192, page 194, page 196, page 198, page 200.)
The forms width can be specified as a function of the current CPI (characters
per inch). The forms width set should not exceed the actual paper width.
The factory default is the maximum printing width divided by the selected
number of characters per inch.
Form Width (in.)
(From page 192, page 194, page 196, page 198, page 200.)
In this submenu, form width is specified in inches. The form width set should
not exceed the actual paper width.
The factory default is the maximum printing width.
Form Width (mm.)
(From page 192, page 194, page 196, page 198, page 200.)
In this submenu, form width is specified in millimeters. The form width set
should not exceed the actual paper width.
The factory default is the maximum printing width.
Forms Handling
(From page 184.)
This submenu allows the user to handle the form in the following ways:
•
Disable (the default). No effect.
•
Auto Eject. Automatically ejects a page at the end of the job to spill out
the last page.
•
Auto TOF. Automatically does a form feed (FF) at the end of each form to
the next top of form.
Format Control
(From page 168, page 170, page 180, page 182.) Enables the printer to
reflect the same spacing as CTPC model printers after absolute and relative
move commands are executed.
•
Disable (the default). Reflects distance, generated by the VGL feature,
PGL feature, and Hex Transparent control code sequence, in the new
position (after horizontal and vertical tabs are executed).
•
Enable. Does not reflect distance, generated by the VGL feature, PGL
feature, and Hex Transparent control code sequence, in the new position
(after horizontal and vertical tabs are executed).
Emulation Submenus
Overview
221
Advertisement
Table of Contents
