C8 - Set Barcode Parameters - IBM 4610 SureMark GR3 Programming Manual Supplement

5.9.1 C8 - SET BARCODE PARAMETERS

This command is used to set the barcode parameters.
5.9.1.1 Command Format
-----------------------------------------------------------------------
BYTE BIT CONTENT
0-1 1B66 - Cmd Prefix
2 C8 - Set Barcode Parameters
3 Cmd. Extension
00 = Size
01 = Station
If Cmd. Extension = 00 specify:
4 Barcode Width
5-7 Barcode Height
If Cmd. Extension = 01 specify:
4 Station
0 = CR
1 = SJ
2 = DI
-----------------------------------------------------------------------
Notes:
1. Ranges supported for horizontal magnification of the line width are:
•
Minimum = 2
•
Maximum = 4
2. Ranges supported for dot height of the barcode are:
•
For CR and SJ stations:
− Minimum = 001
− Maximum = 255
•
For DI station:
− Minimum = 3
− Maximum = 5
5.9.1.2 Set Barcode Parameters Rules
•
The horizontal magnification of the line width default is 3.
•
The dot height default:
− For CR and SJ stations is 162.
− For DI station is 4.
•
CR is the default station.
•
After PLD or J4/CE jumper operation, the printer returns to its default station (CR).
Page 108 of 183 — IBM 4610 SureMark Fiscal Printer Turkey - Models GR3/GR5/GB3/GB5 Programmi
TYPE LENGTH
hex 2
hex 1
hex 1
ASCII 1 (Note 1)
ASCII 3 (Note 2)
hex 1