IBM xSeries 150 User Reference Manual page 153

3
A
Use the pins on the slide rail to align the
A
slide rail to the rack. Use the M6 screws to
bolt the slide rail to the rack (left front of rack
shown here). Repeat this step for the other
slide rail.
5
A
Attention: To avoid injury, do not place your
fingers around the rack-support wheels when
lowering the server onto the rails.
Fully extend the slide rails out of the rack. Lift
the server above the rails; then, rest the rack-
support wheels located on the rear of the
A
server on the slide rails. Lower the front of the
server onto the slide rails.
Note: Be sure the bracket notches
front of the server fit securely on the tabs
located on the front of the slide rails.
4
Use the M6 screws to attach the hinge bracket
A
pin
assembly to the slide rail. (Right rear of rack
shown here).
6
B
C
Use the M4 screws to secure the server to the
rails. Unscrew the rack-support wheels
store them in a safe place.
on the
B
C
Appendix A. Rack Installation Instructions
B
to the rear of the rack. Then, use the hinge
to attach the cable-management
B
A
A
and
A
141