Installing the bezel and front door
Note:
To install the bezel:
To install the server door:
50
IBM® xSeries 150 : User's Reference
The illustrations in this document might differ slightly from your hardware.
1. Place the tabs at the bottom edge of the bezel in the slots at the bottom front of the
server.
2. Press the top of the bezel toward the server until it clicks into place.
1. Set the door on the bottom hinge.
2. Press the flange downward while pressing the top of the door toward the server,
until the flange connects with the top hinge. Then, release the flange.
3. Close and lock the server door.
Attention: Be sure to maintain a clearance of at least 127mm (5inches) on the
front and rear of the server to allow for air circulation.
Bezel
Door
Flange