Adding A Power Supply - IBM xSeries 150 User Reference Manual

AC power LED
DC power LED

Adding a power supply

If you replace the power supply backplane with the power supply backplane option,
you can replace the power supply backplane with an optional backplane that will
enable you to add a second power supply, which gives redundancy and will make the
power supplies hot-swappable. You can also add a third power supply for additional
capacity. After you install a power supply, verify that the power-supply status
indicators (AC Power light and DC Power light) are lit, indicating that the power
supply is operating properly.
Notes:
44
IBM® xSeries 150 : User's Reference
This light provides status information about the power supply. During
normal operation, both the AC and DC power LEDs are on. See "Power
supply LEDs" on page 95 for more information.
This light provides status information about the power supply. During
normal operation, both the AC and DC power LEDs are on. See "Power
supply LEDs" on page 95 for more information.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that has
this label attached. There are no serviceable parts inside these components. If you suspect
a problem with one of these parts, contact a service technician.
1. You do not need to turn off the power to the server to install hot-swap power
supplies.
2. The illustrations in this document might differ slightly from your hardware.