IBM xSeries 150 User Reference Manual page 104

Cod
Function
e
264 Magnetic tape
drive
301 Keyboard
302 Mouse
305 Video monitor
92
IBM® xSeries 150 : User's Reference
Result
Aborted Test setup error: No tape drive found
Failed The load/mount test failed for device n on adapter m
(where n is the number of the device and m is the
adapter number)
The Self-diagnostic failed for device n on adapter m.
(where n is the number of the device and m is the
adapter number)
The unload/eject test failed for device n on adapter m
(where n is the number of the device and m is the
adapter number)
The unload/eject push button test failed for device n
on adapter m
(where n is the number of the device and m is the
adapter number)
The Read/Write Self-diagnostic failed for device n on
adapter m
(where n is the number of the device and m is the
adapter number)
Failed On system board keyboard test failed
Failed On system board pointing deice test failed.
Any message
Text message Action
Check the cable and
power connections to
the drive.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
Refer to the information
provided with the tape
drive.
If the problem persists,
call for service.
The push
Note:
button test is
applicable only
to SCSI tape
drives that
have a push
button.
Insert a new tape
cartridge; then, run the
diagnostic test again.
Refer to the information
that is provided with the
tape drive.
If the problem persists,
call for service.
1. Verify that the
keyboard cable is
connected.
2. If the problem
remains, replace the
keyboard cable.
If the problem persists,
call for service.
Replace the pointing
device. If the problem
persists, call for service.
Refer to the information
that came with the
monitor.