IBM xSeries 150 User Reference Manual page 44

10. Connect any needed cables to the adapter.
11. If you have other options to install or remove, do so now; otherwise, go to
32
IBM® xSeries 150 : User's Reference
6. Remove the adapter from the static-protective package.
Attention: Avoid touching the components and gold-edge connectors on the
adapter.
7. Place the adapter, component-side up, on a flat, static-protective surface.
8. Set any jumpers or switches as described by the adapter manufacturer.
9. Install the adapter:
a. If necessary, remove the adapter support bracket retaining clip.
b. Carefully grasp the adapter by its top edge or upper corners, and align it with
the expansion slot on the system board.
c. Press the adapter firmly into the expansion slot.
Attention: When you install an adapter in the server, be sure that it is
completely and correctly seated in the system-board connector before you
apply power. Incomplete insertion might cause damage to the system board
or the adapter.
d. Replace the retaining clip on the adapter support bracket, if you opened it.
e. Align the bottom tabs of the adapter retention bracket with the holes at the
top of the expansion slots, and press the adapter retention bracket toward the
back of the server until it clicks into the locked position.
Attention: Route cables so that they do not block the flow of air from the fans.
The following illustration shows the rerouting of the SCSI cable if you install a
ServeRAID adapter (remove the cable from SCSI connector A (J17) on the system
board and connect it to the RAID adapter).
Note: The illustrations in this document might differ slightly from your
hardware.
SCSI connector A
"Installing the cover" on page 49.