IBM xSeries 150 User Reference Manual page 90

Table 12. POST error messages
POST message
1162 The serial port configuration conflicts with another device in the system.
Action:
1301 Cable to Information LED panel not detected.
Action:
If the problem persists, call for service.
1302 Cable to Power and Reset pushbuttons not detected.
Action:
If the problem persists, call for service.
1303 I2C cable to Power Backplane not detected.
Action:
If the problem persists, call for service.
1304 Cable to Diagnostic LED panel not detected.
Action:
If the problem persists, call for service.
1600 The Netfinity Advanced System Management processor is not functioning.
Action:
If the problem persists, call for service.
1601 The BIOS needs to be updated.
Action:
If the problem persists, call for service.
1800 A PCI adapter has requested a hardware interrupt that is not available.
Action:
78
IBM® xSeries 150 : User's Reference
1. Make sure the IRQ and I/O port assignments needed by the serial port are
available.
2. If all interrupts are being used by adapters, you might need to remove an
adapter to make an interrupt available to the serial port, or force other adapters
to share an interrupt.
Make sure that the cable to the operator information panel is connected.
Make sure that the cable to the Power and Reset pushbuttons is connected.
Make sure that the cable to the power backplane is connected.
Make sure that the cable to the diagnostic LED panel is connected.
1. Verify that the jumpers for the system-management processor are set correctly.
2. Disconnect the server from all electrical sources, wait for 30 seconds, reconnect
the server to the electrical sources, and restart the server.
1. Disconnect the server from all electrical sources, wait for 30 seconds, reconnect
the server to the electrical sources, and restart the server.
2. If the problem persists, update the BIOS.
1. Make sure that the PCI adapter and all other adapters are set correctly in the
Configuration/Setup Utility program. If the interrupt resource settings are not
correct, change the settings.
2. If all interrupts are being used by other adapters, you might need to remove an
adapter to make an interrupt available to the PCI adapter, or force other
adapters to share an interrupt.
Description