Keypad; Keypad Settings; 28-Key Keypad - CipherLab 9400 Reference Manual

9400 Mobile Computer

1.3 KEYPAD

Silicon rubber has been chosen for their durability and prompt feedback.
Note: Functionality of keys is application-dependent.

1.3.1 KEYPAD SETTINGS

Press [FN] first, and then [0].
The LED backlight of keypad is turned off by default. It can be toggled ON/OFF by the
key combination: [FN] + [0]. It is suggested to turn on the keypad backlight while
working in a dark area; however, using backlight while on battery power will
substantially reduce battery power.
Go to Start > Settings > Control Panel and double-tap the Keyboard icon.
The Character Repeat functionality is enabled by default. You may cancel the check
box to disable it. When enabled, tap, hold, and drag the slider for a desired Repeat
Delay and Repeat Rate.

1.3.2 28-KEY KEYPAD

The 28-key keypad includes alphanumeric, navigation, function keys, and so on. This
keypad is set to numeric mode by default.
ALPHA KEY
This alphanumeric keypad is set to numeric mode by default. The Alpha key serves as a toggle
among numeric, alpha (lower-case alphabetic), and ALPHA (upper-case alphabetic) input modes.
Note: It is not necessary to hold down the [Alpha] key.
The alpha icon will appear on the status bar in a sequence as shown below.
Status Icon Alpha Key
N/A
Press
Press
Note: If you are using the software keypad via SIP, tap CAP (Caps Lock) to toggle
between upper case and lower case alphabetic modes.
16
Reference Manual
one time
two times
Input Mode
Numbers
Small letters
Capital letters