Barcode Reader Settings; Rfid Reader Settings - CipherLab 9400 Reference Manual

4.3.1 BARCODE READER SETTINGS

The barcode reader configurations depend on the scan engine(s) installed. You can tell
which reader is currently in use and make necessary changes on the General tab.
Barcode Reader
CCD/Laser Reader
2D Reader

4.3.2 RFID READER SETTINGS

If the RFID scan engine is present, configurable options will be displayed.
Note: Because it is possible to read barcode and RFID tag at the same time, it is
recommended that only one scan engine is enabled at a time to prevent from
misreading.
Some RFID tags support both read/write operations, on a page-by-page basis. You may
find it necessary to define your own read/write operation. For reference only, the table
below lists the start page for read/write operation on a number of RFID tags.
Start Page Tag Type
-1 Start from byte 0 of the default page (see below) for all tags
3 Mifare Ultralight
4 SR176
3 ICODE SLI
0 LRI512
3 SRF55VxxP
0 EM4135
0 Tag-it HF-I
0 Others
5 ICODE
0 Tag-it
Note: Please refer to the specifications of your RFID tags for memory organization.
Description
If installed, tap the [Barcode Reader] button to configure the reader settings
for CCD or Laser scan engine.
Refer to the Reader Settings Table in
Engine.
The 2D scan engine is capable of reading linear and 2D barcodes.
If installed, tap the [Barcode Reader] button to configure the reader settings
for 2D scan engine.
Refer to the Reader Settings Table in
Chapter 4 Using Applications
Appendix II - CCD/Laser Scan
Appendix III - 2D Scan
Standard
ISO 14443A
ISO 14443B
ISO 15693
ISO 15693
ISO 15693
ISO 15693
ISO 15693
ISO 15693
ICODE® (Phillips)
Tag-it® (TI)
Engine.
75