When A Message Is Displayed; When A Message Is Displayed On The Control Panel - Toshiba e-Studio 901 Operator's Manual

Troubleshooting When Using the Scanner Function

When a Message is Displayed

This section explains likely causes of and possible solutions for error messages
that may appear on the machine's control panel.

When a Message is Displayed on the Control Panel

This section explains causes and remedies if an error message appears on the
display of the control panel.
Important
❒ If a message not described here appears, act according to the message. For in-
formation about how to turn off the main power switch, see About This Ma-
4
chine.
Message
Connection with
LDAP server has
failed. Check the
server status.
LDAP server au-
thentication has
failed. Check the
settings.
Updating the des-
tination list has
failed. Try
again?
The destination
list has been up-
dated. Specified
destination(s) or
sender's name has
been cleared.
Exceeded max.
number of files
which can be sent
at the same time.
Reduce the number
of the selected
files.
48
Cause
A network error has oc-
curred and connection
has failed. Try the opera-
tion once more.
The user name and pass-
word differ from those
set for LDAP Authentica-
tion.
A network error has oc-
curred.
A network error has oc-
curred.
The number of files ex-
ceeded the maximum
number possible.
Solution
Try the operation once more. If the mes-
sage is still shown, the network may be
crowded. Check the information of Sys-
tem Settings. See "System Settings",
General Settings Guide.
Make settings correctly for the user
name and the password for LDAP serv-
er authentication.
Check whether the server is connected.
If a destination or sender's name was al-
ready selected, re-select it after this
message disappears.
Reduce the number of files and send
them again.