Toshiba e-Studio 901 Operator's Manual page 45

Problem
" Updating the
destination
list... Please
wait. Specified
destination(s) or
sender's name has
" ap-
been cleared.
pears.
[List / Test Print] is dis-
abled.
If the printing does not start, consult your service representative.
❖ When the machine is connected to the computer using the interface cable
The following shows how to check the print port when the data-in lamp does
not light up or blink.
Check if the print port setting is correct. When it is connected using a parallel
interface, connect it to LPT1 or LPT2.
For Windows 95/98/Me
A Click the [Start] button, point to [Settings], and then click [Printers].
B Click the icon of the machine. On the [File] menu, click [Properties].
C
Click the [Details] tab.
D In the [Print to the following port:] list, confirm the correct port is selected.
For Windows 2000 or Windows NT 4.0
A Click the [Start] button, point to [Settings], and then click [Printers].
B Click the icon of the machine. On the [File] menu, click [Properties].
C Click the [Ports] tab.
D
In the [Print to the following port(s)] list, confirm the correct port is selected.
For Windows XP
A Click the [Start] button, and then click [Printers and Faxes].
B Click the icon of the machine. On the [File] menu, click [Properties].
C
Click the [Ports] tab.
D In the [Print to the following port(s)] list, confirm the correct port is selected.
For Windows Server 2003
A Click the [Start] button, point to [Settings], and then click [Printers and Faxes].
B
Click the icon of the machine. On the [File] menu, click [Properties].
C Click the [Ports] tab.
D In the [Print to the following port(s)] list, confirm the correct port is selected.
Cause
The destination list is be-
ing updated from the net-
work using
SmartDeviceMonitor for
Admin.
A mechanical error might
have occurred.
When You Cannot Print
Solution
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on
the number of destinations to be updat-
ed, there may be some delay before you
can resume operation. Operations are
not possible while this message is dis-
played.
Contact your service representative.
See "List/Test Print", General Settings
Guide.
3
39