When You Cannot Make Copies As Wanted - Toshiba e-Studio 901 Operator's Manual

When You Cannot Make Copies As Wanted

This section explains likely causes of and possible solutions for unclear copies.
❖ Basic
Problem
Misfeeds occur frequently. The number of sheets
Misfeeds occur frequently. The paper is damp.
Misfeeds occur frequently. The paper is too thick or
Misfeeds occur frequently. The copy paper is wrin-
Misfeeds occur frequently. Printed paper is being
Copy paper becomes
creased.
Copy paper becomes
creased.
Copies are not stapled.
Copies are not stapled.
Copies are not stapled.
Staples are wrongly posi-
tioned.
You cannot combine sev-
eral functions.
Cause
loaded exceeds the capac-
ity of the machine.
too thin.
kled or has been fold-
ed/creased.
used.
The paper is damp.
The paper is too thin.
There are jammed staples
in the stapler.
The number of copies ex-
ceeds the capacity of the
stapler.
Copy paper is curled.
Originals are not set cor-
rectly.
Selected functions cannot
be used together.
When You Cannot Make Copies As Wanted
Solution
Load paper only as high as the upper
limit markings on the side fence of the
paper tray or bypass tray. See "Copy
Paper", About This Machine.
Use paper that has been stored in the
recommended temperature and hu-
midity condition. See "Copy Paper",
About This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Use recommended paper. Use paper
that has been stored in the recommend-
ed temperature and humidity condi-
tion. See "Copy Paper", About This
Machine.
Use recommended paper. Do not use
paper that has been already copied or
printed onto. See "Copy Paper", About
This Machine.
Use paper that has been stored in the
recommended temperature and hu-
midity condition. See "Copy Paper",
About This Machine.
Use recommended paper. See "Copy
Paper", About This Machine.
Remove jammed staples. See p.100 "Re-
moving Jammed Staples".
Check the stapler capacity. See "Sup-
plementary Informations", Copy/Doc-
ument Server Reference.
Turn the copy paper over in the tray.
Check the correct position to place the
originals. See "Staple", Copy/Docu-
ment Server Reference.
Check the combination of functions
and make the settings again. See "Func-
tion Compatibility", Copy/Document
Server Reference.
2
27