Toshiba e-Studio 901 Operator's Manual page 34

Troubleshooting When Using the Copy Function
Problem
When sorting, the pages
are divided into two
blocks.
Paper does not output
during printing with sta-
pling.
2
Images are skewed.
Images are skewed.
❖ Edit
Problem
In Double Copies mode,
parts of the original im-
age are not copied.
In Border, Centre, or Cen-
tre/ Border mode, parts
of the original image are
not copied.
In Border, Centre, or Cen-
tre/ Border mode, parts
of the original image are
not copied.
In Margin Adjustment
mode, parts of the origi-
nal image are not copied.
In Margin Adjustment
mode, parts of the origi-
nal image are not copied.
In Image Repeat mode,
the original image is not
copied repeatedly.
28
Cause
The memory became full
in the middle of sorting
and the pages were deliv-
ered in two blocks.
When you stop printing
while using the staple
function, paper not sta-
pled during printing may
be left in the staple unit.
The side fences in the pa-
per feed tray is not
locked.
The paper is feeding in at
a slant.
Cause
Combination of original
and copy paper is not cor-
rect.
You set a wide erased
margin.
Originals are not scanned
correctly.
You set a wide erased
margin.
There is a lack of margin
space on the opposite
side of the binding posi-
tion.
You selected copy paper
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
Solution
You can interrupt copying when the
memory becomes full. See "Memory
Full Auto Scan Restart", General Set-
tings Guide.
Press the {Clear Modes} key and cancel
copy settings, including stapling.
Make sure the paper guide is locked.
See p.70 "Changing the Paper Size".
Load the paper correctly. See p.59
"Loading paper".
Solution
Select A3L for A4K originals and A4
for A5 originals.
Make the margin width narrower. You can
adjust it between 2 - 99 mm (0.1" - 3.9").
See "Erase Border Width" and "Erase Cen-
tre Width", General Settings Guide.
Place the originals correctly.
Set a narrower margin with User Tools.
You can set the width between 0 - 30
mm (0" - 1.2").
See "Front Margin: Left/Right", "Back
Margin: Left/Right", "Front Margin:
Top/Bottom" and "Back Margin:
Top/Bottom", General Settings Guide.
Set a narrower margin with User Tools.
You can set the width between 0 - 30
mm (0" - 1.2").
See "Front Margin: Left/Right", "Back
Margin: Left/Right", "Front Margin:
Top/Bottom" and "Back Margin:
Top/Bottom", General Settings Guide.
Select copy paper larger than the origi-
nals or select the proper reproduction
ratio.