HearthStone Windsor Bay 8830 Owner's Manual And Installation Manual page 9

HearthStone Quality Home Heating Products Inc
L I
IGHTING NSTRUCTIONS
The gas control knobs and the piezo
NOTE:
ignitor are located in the lower right side
door.
1. STOP! Read the What To Do If You
Smell Gas! Warning (on the cover of
this manual).
2. Set the on/off/T'STAT
thermostat
to the "OFF" position.
3. Push in and turn gas control knob
clockwise to "OFF". (If not previously
lit, the knob should be in this position.)
4. Wait (5) five minutes to clear out any
gas. If you then smell gas, STOP! Smell
all around the appliance area for gas.
Be sure to smell next to the floor because
some gases are heavier than air and will
settle on the floor. If you smell gas
immediately follow the What To Do If
You Smell Gas! warning on the cover of
this Manual. If you do not smell gas,
proceed to the next step.
5. Turn gas control knob counter-clockwise
to "PILOT".
6. Push in control knob all the way and
hold in. Immediately light the pilot with
the piezo lighter (push in and "click" the
red piezoelectric spark ignitor button
several times until lit). Continue to hold
the control knob in for about 20 seconds
after the pilot is lit. Release the knob and
it will pop back out. Pilot should remain
lit. If the pilot goes out, repeat the
operation.
• If knob does not pop out when released,
stop, shut off the gas supply to the heater
and immediately call a qualified service
technician or gas supplier.
• If the pilot will not stay lit after several
tries, turn the gas control knob "OFF"
7. After the pilot lights, turn gas control
8.
switch or
9. Shut the gas control valve access door.
9
Windsor Bay Model #8830
and call a qualified service technician or
gas supplier.
knob counter-clockwise to "ON".
If the ON/OFF/T'STAT switch is set to
"ON", the stove should now be lit. If the
thermostat (or remote)
installed, set the
switch to "T'STAT"
thermostat (or remote) to "ON". Then
set the desired temperature.
has been
ON/OFF/T'STAT
and turn the