Table of Contents
Advertisement
HearthStone Quality Home Heating Products Inc
When the unit is first lit, especially when
cool, it is normal to experience some
condensation on the inside of the glass
window. This condensation will burn off
within the first few minutes of operation. If
continuous condensation or water drips are
noted from any part of the unit, immediately
discontinue operation of the unit and contact
a qualified service technician.
Routine Maintenance and
Care
The Windsor Bay requires minimal routine
maintenance and care. The unit should
always be cool and off when being cleaned.
C
LEANING
¦
WARNING: Do not clean the unit
when hot. The unit should receive
regular cleaning on, under, and around
the stove to prevent the buildup of dust
and lint. The exterior surfaces of the unit
can be cleaned using soap, water, and a
soft cloth. Do not use abrasive or
chemical cleaners and take care not to
scratch the stones, glass or enamel finish
(if so equipped) when cleaning the unit.
The use of chemical wax based cleaners
or polishes are not recommended due to
the potential for discoloration or the
enamel when the residue of the cleaners
or polishes is exposed to heat.
F
, P
, & B
IREBOX
ILOT
T
UBES
The firebox, pilot & burner tubes should
receive periodic cleaning to prevent the
accumulation
of
dust,
Regularly check to insure the area around
the Windsor Bay is kept free and clear from
combustible materials, gasoline, and other
flammable vapors and liquids. Check that
the flow of ventilation air is not obstructed.
URNER
lint
and
debris.
11
Windsor Bay Model #8830
Once a year the unit and its venting
system should be inspected by qualified
service personnel to ensure that it is clean,
free of obstruction, safe, and in good
working order. If service or maintenance
is required, qualified service personnel
should perform it.
Installer's Information
C
ODES
Adhere to all local codes or, in their
absence,
the
latest
NATIONAL FUEL GAS CODE ANSI
Z223.1 (NFPA 54) or CAN/CGA B149
Installation Code that can be obtained from
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
OR
NATIONAL FIRE PROTECTION
ASSOCIATION, INC.
BATTERY MARCH PARK
QUINCY, MA 02269
The appliance when installed, must be
electrically
connected
accordance with local codes or, in the
absence of local codes, with the current
NFPA 70-National Electrical Code or CSA
C22.1-Canadian Electric Code.
A
manufactured
home
installation
must
Manufactured
Home
Safety Standard, Title 24 CFR, Part 3280
(U.S.) or Standard for Manufactured Home
Installation,
ANSI/NCBCS
Standard for Gas Equipped Recreational
Vehicles
and
mobile
Z240.4.CAN/SCA
Z240
(Installer l'appareil selon les codes ou
règlements locaux, ou, en l'absence de tels
edition
of
THE
:
and
grounded
in
(mobile)
OEM
conform
with
the
Construction
and
A225.1
or
Housing,
CSA
MH
(Canada).
Hide quick links:
Advertisement
Table of Contents
