HearthStone Windsor Bay 8830 Owner's Manual And Installation Manual page 23

HearthStone Quality Home Heating Products Inc
collar extends further to the right of the
stove (refer to Figure 1, on page 7). Slide
a hose clamp over the ends of both
flexible vent pipes. Place the flexible
vent pipe marked "intake" onto the
intake collar, place the flexible vent pipe
marked "exhaust"
collar. Secure them to the collar adaptors
by tightening the hose clamps with a
slotted screwdriver or 5/16" nut driver.
→ Repeat this process on the upper portion
of the vent (flex pipes to co-linear to co-
axial adaptor). Important: Make certain
the pipe hooked to the exhaust on the
stove hooks to the exhaust portion of the
co-linear to co-axial adaptor. Be sure to
meet all the manufacturers requirements
when installing the adaptor and cap
assembly. Follow
instructions when installing the same.
→ The
following
observed when installing the vent pipes:
• DO NOT crimp or rupture the vent
pipes.
• BOTH the exhaust and intake vent pipes
must reline the entire length of the
chimney. The exhaust and inlet vents
must terminate above the top of the
chimney using
termination components listed in these
instructions.
• DO NOT install the venting into a
chimney serving another appliance, be it
fossil fuel or solid fuel.
I T
NSTALLING HE
S /I
URROUNDS NSERT
You will need to determine which surround
set you will need, the standard or the large
using the following dimensions:
Standard Surround Set
Height: 29"
Width: 38.5"
onto the exhaust
the manufactures
guidelines must be
the appropriate vent
Large Surround Set
Height: 32"
Width: 43.5"
Each surround set will have the following
hardware:
4 – Phillips Panhead Bolts (joins
surround side panels to surround top
panel)
NOTE: The large surround set uses 6
Panhead screws to join the side
surrounds to the top surrounds.
4 – Phillips Pan Hd. ¼-20 x 1-1/4"
Bolts (joins assembled surround to
insert)
2 – Phillips
(attaches switch plate to surround)
→ Before installing the surround, locate the
upper heat exchanger baffle on the top of
the insert. Remove the front plate
portion of this piece by removing the
three Phillips screws located on the face
of the heat exchange baffle. Set this
piece aside for now, it will be put back
on after the surround is installed.
→ Attach the side surrounds to the top
surround piece by attaching the four (or
six) Phillips Panhead screws through the
back of the surround pieces (two or three
through each side, upper left and upper
right).
→ Place the surround set onto the face of
the insert. Attach the top of the surround
by turning two of the Phillips Panhead
bolts through the upper holes in the
surrounds. These will line up with speed
nuts on the heater. Fasten the bottom of
the surround to the heater by inserting
the other two Phillips Panhead bolts
through the
surrounds. These bolts will line up with
23
Windsor Bay Model #8830
Roundhead Bolts
lower holes on the