HearthStone Windsor Bay 8830 Owner's Manual And Installation Manual page 24

HearthStone Quality Home Heating Products Inc
speed nuts located on the insert. (refer to
Figure 7 for assembly).
→ Slip the switch plate into position on the
right side of the surround panel. Fasten it
to the surround using the two Roundhead
Phillips screws.
→ WARNING: Failure to position the
parts in accordance with the Figures in
this manual, or failure to use only parts
specifically approved with this appliance
may result in property damage or
personal injury.
→ Place a level on top of the unit. Leg
leveling bolts are located in the front and
rear of the base plate. Adjust the rear
leveling bolts now as they will not be
accessible once the unit is fully inserted
into the fireplace.
→ Push the unit as far into the fireplace as
you can, leaving just enough room for
the fan power cord to exit on the bottom
right side, between the surround and
fireplace.
→ Place
the front
removed from the upper heat exchanger
baffle) back into position on the face of
plate (previously
24
Windsor Bay Model #8830
the unit. Re-attach to the unit with the
three Phillips screws.
→ Before replacing the front façade,
carefully unwrap and place the log set
into the unit. Refer to Log Set
information section of this manual for
the precise positioning of the log.
→ Place the front façade back onto the
insert, retaining it with the 4 Allen Flat
Head bolts. Two of these bolts screw
into threaded inserts while two screw
into speed nuts.
→ Replace the front grill and retain it with
the two Phillips screws.
→ Place the top grill into the top of the
heater. Carefully set the top stone into
the top grill.
→ Place a level on the top of the unit. Two
leveling leg bolts are located in the front
of the base plate. Use a wrench to turn
these bolts up or down as necessary to
level the unit. Note, leveling bolts are
also located in the back of the base, but
the insert must be pulled out of the
fireplace to gain access to them.