Unpack And Inspect For Damage - HearthStone Windsor Bay 8830 Owner's Manual And Installation Manual

HearthStone Quality Home Heating Products Inc
règlements, selon les Codes d'installation
CAN/CGA-B149.)
I R
TEMS EQUIRED FOR
I
NSTALLATION
* External regulator (for propane/L.P.G.
only)
* Piping which complies with local codes
* Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur
compounds)
* Manual shutoff valve
* Sediment trap
* Tee joint
* Pipe wrench
* Phillips head screwdriver
* Other parts as required by local code
*Safety Glasses
*Gloves
P L
ACKING IST
1-Windsor Bay Gas-Fired Heater
1-Surround Set (3 pcs.) (optional)
1-Hardware Set
1-Accessory Box
1-Thermostat with 40' wire
1-Owners Manual
1-Warranty Validation Form
1-Top Center Stone
1-Top Center Grill
2-Embers
1-Andiron
1-Ember Screen
6-Decorative Ceramic Fiber Logs
1-Flex Gas Tube
1-Restrictor Disc
U
NPACKING AND
U I
NPACK AND NSPECT FOR
The Windsor Bay is packaged by the
manufacturer to withstand shipment without
damage. However, damage can occur during
transit so take care to inspect for damage
when unpacking and installing the unit.
I
NSPECTION
D
AMAGE
If
any damage or missing parts are detected,
immediately contact your dealer.
Do not install or put into service a
damaged or incomplete heater.
Within the accessory box is the top center
stone, top center grill, thermostat, and
thermostat wire.
installation instructions for these parts will
follow the inspection for damage.
Unbolt and lift off the pallet and partially
insert it into the fireplace, (with regards to
the Clearances To Combustibles section of
this manual).
Inspect the stove
concealed damage. The unit should appear
to be square and true. The stones should be
whole and without
breakage. The sheet metal parts should be
smooth and free of bends and/or dents. If the
heater is enameled, the enameled cast iron
should be free of chips and/or cracks.
If visible or concealed damage is found or
suspected, contact your local dealer for
instructions. Refer to Figure 7 on page 23
for the next step. To open the firebox,
remove the front grill, and the 4 screws
holding on the front façade. Inspect the log
for damage. It is important to wear safety
goggles and gloves when handling the log
set. If a damaged log is encountered, contact
your local dealer for a replacement log. Put
the log set aside. It will be installed later.
Sediment Trap
12
Windsor Bay Model #8830
The location and
for visible and/or
cracks, chips,
Gas Suppl y
Inlet
To Equi p ment
Tee Fitting
Inlet
3" MIN.
Nipple
C a p
or