Log Placement - HearthStone Windsor Bay 8830 Owner's Manual And Installation Manual

HearthStone Quality Home Heating Products Inc

Log Placement

CAUTION: Fragile! Handle log set with
care. Always wear gloves and safety goggles
while handling the log set.
Only the decorative ceramic fiber log set
supplied with the unit should be placed in
the firebox. Do not place any other ceramic
logs, wood logs, or other materials in the
firebox. If the log set is damaged or broken
contact your dealer for replacement.
decorative ceramic fiber log set will last a
long time, however, they will break if
subjected to rough or improper handling.
Exact positioning of the log set is required in
order to obtain a pleasing flame pattern and
efficient combustion.
placement may cause
excess thermal stress on the log set and
stove parts, reduced efficiency, and high
levels of carbon monoxide. If the log set
does not set into the firebox exactly as
outlined, contact your dealer for assistance.
I
NSTALLATION OF THE
(Refer to figures 8 & 9 for log set assembly)
NOTE: The rear and middle logs with
"locator" posts should be on the right side of
the firebox when installed.
1. The log set and an ember screen
must be placed in the firebox at their
precise location. Remove the front
façade as described in the 'Inspect
For Damage' section of this manual.
2. Remove the
around the log set assembly. Be
careful not to damage the log set
when unpacking.
3. Using the 'locator' tabs on the
bottom of the rear logs, position the
rear logs on the ridge to the back of
The
Incorrect log
carbon build-up;
L S
OG ET
packaging material
the firebox near the base of the
firebox.
4. Place the two middle logs with
grooves over the two burner tubes.
The face should be parallel to the leg
of the burner tubes. Now the center
log will fit over the 'locator' posts on
both the rear and middle logs.
5. Position the front log in front of the
burner tubes on the base of the
firebox. Place the ember screen over
the two burner tubes. It will fit
tightly around the right middle log
and in front of the left middle log.
6. Place the
andiron in the groove on the front
log.
7. NOTE When installing the embers be
sure to leave gaps throughout the
burner. (This is important to allow for
proper ignition of the burner tube) It is
recommended
arranging of the embers to achieve a
pleasing flame pattern. Leave embers
off the pilot to allow the pilot flame to
ignite the ignition ports on the burner
tube. Open the two bags of embers and
distribute the large embers evenly across
the burner tubes, on top of the ember
screen. Next, scatter the small embers
throughout the burner to create a
pleasant flame pattern, leaving gaps
throughout the burner.
8. Close the stove. With an Allen
wrench, replace the front façade by
following
described in the Assembly Of The
Unit section of this manual. Be sure
to evenly draw the screws tight to
the front of the firebox. Make sure
the front is properly secured to the
firebox before turning the unit on. Be
careful not to chip the enamel when
fastening
26
Windsor Bay Model #8830
andiron support and
to experiment with
the instructions
the front.
as