Greasing Lubricating Points Fitted With Grease Nipples; Supporting The Tractor - Valtra T144 Operator's Manual

4. Maintenance
6. Remove the battery casing.
7. Remove any dirt or hay from the fuel-operated heater and its surroundings.
GUID-3F7D2A77-613B-4EFF-892C-4D45D472FE21
1. Fuel-operated heater
2. Silencer
8. Clean fuel-operated heater and its surroundings with a brush and
compressed air.
Make sure the surface of the silencer is clean. If the tractor is equipped with
bottom plate, clean it as well.
9. Fit the battery casing.
10. Connect the hoses and electric connectors to the windscreen washer fluid
reservoir.
11. Attach the main electric centre to the battery casing.
Tighten the 4 fastening screws.
12. Attach the engine electric centre to the battery casing.
13. Close the battery casing.
4.3.2

Greasing lubricating points fitted with grease nipples

1. Always clean the grease nipples before applying the grease gun.
2. Apply grease through the nipples until clean grease oozes out (unless
otherwise instructed).
NOTE: Preferably carry out lubrication with bearing points and joints
unloaded and with the bearings in different positions.
3. Wipe away superfluous grease which has been pressed out at the lubricating
point.
4.3.3

Supporting the tractor

Follow these instructions when supporting the tractor.
• Make sure that the surface below the tractor is flat and hard.
• Make sure that the jack you use is sufficient and that you can lift the tractor
with it.
2
- 258 -
1