Table of Contents
Advertisement
3. Operation
2. To increase the speed to normal, change the position of the lift/stop/lower
switch again.
3.12.4
Using the lift/stop/lower switch
The lift/stop/lower switch has three positions.
GUID-345DBC6B-8242-4B4E-9860-D3193568D8D1
1. Lift/stop/lower switch
2. Position control knob
•
Press down the symbol side of the lift/stop/lower switch.
The lower links are moved to the height set by the position control knob. This
is called the Autocontrol position.
NOTE: When the draft control is in use, the linkage movements can be large
and undeterminable.
•
Press down the side of the lift/stop/lower switch opposite to the symbol.
The lower links are moved to the height set by the lifting height selector. This
is called the transport position.
•
To stop the lower links, set the lift/stop/lower switch to the centre position.
This is called the stop position.
3.12.5
Using the position control knob
The position control knob allows continuous control of the lower links' position.
You can use the knob to lift or lower the lower links. You can also use to knob to
set the height where the links move when using the Lift/stop/lower switch
lowering (Autocontrol) function.
NOTE: The position of the lower links is displayed on the Proline instrument
panel display in the rear lower links' position view.
2
1
- 170 -
Advertisement
Table of Contents
