Using Auto-Guide With Quicksteer; Resetting The Auto-Guide Steering Valve - Valtra T144 Operator's Manual

3. Operation
3.20.2

Using Auto-Guide with QuickSteer

If you want to use Auto-Guide with QuickSteer, turn the Auto-Guide receiver on
and activate the QuickSteer.
GUID-5240F5F8-BC57-4C04-B1EC-53B91E356645
1. QuickSteer control knob
2. QuickSteer activation button
3. Auto-Guide receiver on/off button
1. Press the Auto-Guide receiver on/off button on the side panel to turn the
Auto-Guide receiver on.
2. Press the QuickSteer activation button to activate the steering valve.
The QuickSteer activation button light is lit green, and the QuickSteer symbol
is displayed on the Proline instrument panel. When using QuickSteer, do not
turn the Auto-Guide steering valve on.
3. Turn the QuickSteer control knob to set the steering speed.
To deactivate the QuickSteer, press the QuickSteer activation button again.
3.20.3

Resetting the Auto-Guide steering valve

If the light on the Auto-Guide steering valve on/off button is flashing, there is a
fault in the steering valve. The fault code is shown on the A-pillar display. Reset
the steering valve to recover from the fault.
• Press the steering valve on/off button once.
The steering valve is turned off after which the system turns the valve back
on.
If the light is still flashing, the fault persists. In this case, contact an
authorised Valtra workshop.
1 2
3
- 226 -