Table of Contents
Advertisement
3. Operation
3.2.13
Control stop
The control stop is used when the tractor is running an implement in stationary
mode (for example a compressor or pump) and the operator is not in the cab.
Using the control stop reduces the risk of more serious damage to the engine or
in the transmission. The control stop is extra equipment.
NOTE: When starting the engine, the control stop must be disengaged.
Otherwise the engine does not start.
NOTE: Do not use the control stop when driving. The control stop automatically
stops the engine if the stop light is lit.
IMPORTANT: If the control stop stops the engine, the fault must be found and
repaired before the engine is started again.
3.2.14
Using the control stop
1
GUID-BA45B7C9-2B6D-4C8D-9649-5F83836A74CB
1. Control stop switch
•
To activate the control stop, press down the symbol side of the control stop
switch.
Release the locking device by pushing it towards the middle of the switch.
•
To deactivate the control stop, press down the side of the control stop switch
opposite to the symbol.
3.2.15
Using the ignition switch
The ignition switch has four positions: OFF, ACC, power on and start position. In
the ACC position, for example, the radio and cold box are powered.
After turning the ignition key to OFF position, there is a delay before the main
power switches off.
- 74 -
Advertisement
Table of Contents
