The Edit L2Tp Tunnel Screen - ZyXEL Communications LTE7410 User Manual

12.3 The Edit L2TP Tunnel Screen

Use this screen to modify a L2TP VPN tunnel. Click Security > L2TP VPN and then the Edit icon
to open the following screen.
Figure 65 Security > L2TP VPN > Modify
The following table describes the labels in this screen.
Table 35 Security > L2TP VPN > Modify
LABEL
Active
Default Route
L2TP Tunnel
Name
L2TP Protocol
Layer
Secure Gateway
Address
Username
Password
Auth
OK
Back
Chapter 12 L2TP VPN
DESCRIPTION
Click this to activate the L2TP VPN.
Click this to activate the default route.
This shows the IP address that the LTE Device assigned for the remote user's computer to
use within the L2TP VPN tunnel.
Select which OSI layer (Layer2 or Layer3) protocol the L2TP tunnels over a network. Use
Layer3 L2TP to have the LTE Device tunnel OSI layer 3 protocol over a network and
Layer2 L2TP for OSI layer 2 protocol (BCP tunnel).
If you configure this field to 0.0.0.0 or leave it blank, the LTE Device will use the address
in the Secure Gateway Address field (refer to the Secure Gateway Address field
description).
The remote user must log into the LTE Device to use the L2TP VPN tunnel. This shows a
user or user group that can use the L2TP VPN tunnel.
Enter the password for the user.
Select the protocol (EAP, MSCHAPv1 or MSCHAPv2) the LTE Device uses for user
authentication.
Click this button to save your settings back to the LTE Device.
Click this button to return to the previous screen without saving any changes.
LTE7410 User's Guide
88