The Lan Setup Screen - ZyXEL Communications LTE7410 User Manual

5.2 The LAN Setup Screen

Click Network Setting > Home Networking to open the LAN Setup screen. Use this screen to
set the Local Area Network IP address and subnet mask of your LTE Device and configure the DNS
server information that the LTE Device sends to the DHCP client devices on the LAN.
Figure 15 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 6 Network Setting > Home Networking > LAN Setup
LABEL
LAN IP Setup
IP Address
Subnet Mask
DHCP Server State
DHCP
IP Addressing Values
Chapter 5 Home Networking
DESCRIPTION
Enter the LAN IP address you want to assign to your LTE Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your LTE Device automatically computes the subnet
mask based on the IP address you enter, so do not change this field unless you are
instructed to do so.
Select Enable to have your LTE Device assign IP addresses, an IP default gateway and
DNS servers to LAN computers and other devices that are DHCP clients.
If you select Disable, you need to manually configure the IP addresses of the
computers and other devices on your LAN.
If you select DHCP Relay, the LTE Device acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the clients. Enter the IP
address of the actual, remote DHCP server in the Remote DHCP Server field in this
case.
When DHCP is used, the following fields need to be set:
LTE7410 User's Guide
32