ZyXEL Communications LTE7410 User Manual page 52

The following table describes the labels in this screen.
Table 12 Routing: Add/Edit
LABEL DESCRIPTION
Active Select or clear this field to turn the static route on or off.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
Address based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Interface You can decide if you want to forward packets to a gateway IP address or a bound
interface.
If you want to configure bound interface, choose an interface through which the traffic is
sent. You must have the WAN interfaces already configured in the Broadband screen.
Gateway IP You can decide if you want to forward packets to a gateway IP address or a bound
Address interface.
If you want to configure Gateway IP Address, enter the IP address of the next-hop
gateway. The gateway is a router or switch on the same network segment as the device's
LAN or WAN port. The gateway helps forward packets to their destinations.
Metric This is the "cost" of transmission for routing purposes.
OK Click this to save your changes.
Back Click this to exit this screen without saving.
Chapter 6 Static Route
LTE7410 User's Guide
52