Before You Begin - ZyXEL Communications LTE7410 User Manual

5.4.1 Before You Begin

Find out the MAC addresses of your network devices if you intend to add them to the Static DHCP
screen.
Use this screen to change your LTE Device's static DHCP settings. Click Network Setting > Home
Networking > Static DHCP to open the following screen.
Figure 17 Network Setting > Home Networking > Static DHCP
The following table describes the labels in this screen.
Table 8 Network Setting > Home Networking > Static DHCP
LABEL
Add new static
lease
#
Active
MAC Address
IP Address
Modify
If you click Add new static lease in the Static DHCP screen, the following screen displays.
Figure 18 Static DHCP: Add New Static Lease
The following table describes the labels in this screen.
Table 9 Static DHCP: Add New Static Lease
LABEL
MAC Address
IP Address
Chapter 5 Home Networking
DESCRIPTION
Click this to add a new static DHCP entry.
This is the index number of the entry.
Displays whether the static DHCP entry is on or off.
The MAC (Media Access Control) or Ethernet address on a LAN (Local Area Network) is
unique to your computer (six pairs of hexadecimal notation).
A network interface card such as an Ethernet adapter has a hardwired address that is
assigned at the factory. This address follows an industry standard that ensures no other
adapter has a similar address.
This field displays the IP address relative to the # field listed above.
Click the Edit icon to configure the connection.
DESCRIPTION
Enter the MAC address of a computer on your LAN.
Enter the IP address that you want to assign to the computer on your LAN with the MAC
address that you will also specify.
LTE7410 User's Guide
38