ZyXEL Communications LTE7410 User Manual page 98

Table 39 VoIP > SIP > SIP Service Provider > Edit (continued)
LABEL DESCRIPTION
Min-SE Enter the minimum number of seconds the LTE Device lets a SIP session remain idle
(without traffic) before it automatically disconnects the session. When two SIP devices
start a SIP session, they must agree on an expiration time for idle sessions. This field is
the shortest expiration time that the LTE Device accepts.
Dialing interval selection
Dialing interval Enter the number of seconds the LTE Device should wait after you stop dialing numbers
selection before it makes the phone call. The value depends on how quickly you dial phone
numbers.
Phone Key Config
Use this section to customize the phone keypad combinations you use to access certain features on the LTE
Device.
Caller Display Call This code is used to display the caller ID for outgoing calls.
Caller Hidden Call This code is used to hide the caller ID for outgoing calls.
One Shot Caller This code is used to display the caller ID only for the phone call your are going to make.
Display Call
One Shot Caller This code is used to hide the caller ID only for the phone call your are going to make.
Hidden Call
Call Waiting This code is used to turn the call waiting feature on. With call waiting, you hear a special
Enable beep notifying you of another incoming call while you have a call. It allows you to place
the first incoming call on hold and answer the second call so that you won't miss any
important calls.
Call Waiting This code is used to turn the call waiting feature off.
Disable
One Shot Call This code is used to enable call waiting only for the phone call your are going to make.
Waiting Enable See the description for the Call Waiting Enable field for more information.
One Shot Call This code is used to disable one shot call waiting.
Waiting Disable
Call Transfer This code is used to enable call transfer that allows you to transfer an incoming call (that
you have answered) to another phone.
Unconditional Call This code is used to enable unconditional call forwarding. Incoming calls are always
Forward Enable forwarded to a specified number without any condition.
Unconditional Call This code is used to disable unconditional call forwarding.
Forward Disable
No Answer Call This code is used to enable call forwarding when there is no answer at a SIP number (no
Forward Enable one picked up the connected phone that uses the SIP number).
No Answer Call This code is used to disable call forwarding when there is no answer at a SIP number (no
Forward Disable one picked up the connected phone that uses the SIP number).
Call Forward This code is used to enable call forwarding when the phone is busy.
When Busy
Enable
Call Forward This code is used to disable call forwarding when the phone is busy.
When Busy
Disable
Do Not Disturb This code is used to turn the do not disturb feature on. This has the LTE Device reject all
Enable calls destined to the phone line.
Do Not Disturb This code is used to turn the Do Not Disturb feature off.
Disable
Chapter 14 VoIP
LTE7410 User's Guide
98