Edit Alarm Event Setup Screen; Figure 145 Alarm Event Setup Edit; Table 103 Alarm Event Setup - ZyXEL Communications IES-1248-51V User Manual

Chapter 44 Alarm
The following table describes the labels in this screen.

Table 103 Alarm Event Setup

LABEL
Index
Alarm
Condition Code
Condition
Facility
SNMP
Syslog
Severity
Clearable

44.4.1 Edit Alarm Event Setup Screen

Use this screen to specify the severity level of an alarm(s) and where the system
is to send the alarm(s).
To open this screen, click Alarm > Alarm Status. Then, click an alarm's index
number.

Figure 145 Alarm Event Setup Edit

324
DESCRIPTION
This field displays the index number of the alarm in the list. Click this
to specify the severity level of an alarm(s) and where the system is to
send the alarm(s). See Section 44.4.1 on page
This field displays the alarm category to which the alarm belongs.
eqpt represents equipment alarms.
dsl represents Digital Subscriber Line (DSL) alarms.
enet represents Ethernet alarms.
sys represents system alarms.
voip represents Voice over IP alarms.
This field displays the condition code number for the specific alarm
message.
This field displays a text description for the condition under which the
alarm applies.
This field displays the log facility (Local 1~ Local 7) on the syslog
server where the system is to log this alarm. This is for alarms that
send alarms to a syslog server.
This field displays "V" if the system is to send this alarm to an SNMP
server. It displays "-" if the system does not send this alarm to an
SNMP server.
This field displays "V" if the system is to send this alarm to a syslog
server. It displays "-" if the system does not send this alarm to a
syslog server.
This field displays the alarm severity level (critical, major, minor or
info).
This displays "V" if the alarm clear command removes the alarm from
the system. It displays "-"if the alarm clear command does not
remove the alarm from the system.
324.
IES-1248-51V User's Guide