Hangar 9 Composite QQ Yak-54 2.6m Instruction Manual page 37

rudder serVo and pull-pull cable installation • einbau Von höhenruderserVo und pull-pull-kabel • assemblage du câble « pull-pull » et du serVo
de la gouVerne de direction • installazione del serVo del timone e dei caVetti di comando
10
Using a crescent wrench and ball driver, install the ball link in the rudder
control horn
11
Exit the cable through the fuselage opening. Cables exit straight.
12
Tape the rudder at the center, using masking tape and power on the servo
by connecting it to the receiver.
37