Hangar 9 Composite QQ Yak-54 2.6m Instruction Manual page 35

rudder serVo and pull-pull cable installation • einbau Von höhenruderserVo und pull-pull-kabel • assemblage du câble « pull-pull » et du serVo
de la gouVerne de direction • installazione del serVo del timone e dei caVetti di comando
4
Temporarily connect the servo to the receiver and power up the receiver.
Install the arm perpendicular to the output shaft. Use sub-trim if necessary
5
Apply thread lock to the servo arm center screw. Install the center screw and
both set screws.
6
Cut the pull-pull cable in half
35