Table of Contents
Advertisement
aileron serVo tray installation •
22
Apply finishing epoxy and lay the fiberglass. Work the fiberglass cloth with
the back of a hobby knife for a tight contact at the corner. Then brush some
finishing epoxy for the cloth once more.
20
20
Once the fiberglass resin is cured, using a hobby knife, cut the excess
fiberglass cloth.
21
Make all four servo trays using the same method. As it has been stated, be
sure to thoroughly scratch the surfaces and then clean with acetone. These
steps are extremely important otherwise tray can break and cause flutter and
loss of control of the model.
Advertisement
Table of Contents
