Pressure Lever Assembly - Riso CZ180 Series Technical Manual

3. Pressure Lever Assembly

REMOVAL
) Remove the Drum out of the machine and turn OFF the machine power.
2) Remove the Rear cover. (M3x8 screws; 5 pcs)
3) Open the PCB bracket on the rear of the machine. (M3x8; 4 pcs)
4) Being careful not to injure yourself, use your hand to push on the Pressure lever and push the
Solenoid lever down to unhook the both from each other.
5) Pay caution not to injure yourself, remove the Pressure spring.
6) Loosen the set screws on the Pressure lever assembly and remove the Pressure lever assembly
from the machine. (M6x8 set screws; 2 pcs)
Adjustment after Assembly
) Mounting position of Pressure lever assembly.
CZ80 / CV860 Rev. .0
RISO Inc. Technical Services & Support
CHAPTER 6: PRESS SECTION
Set screw
Set screw
6 - 5
US.RISO.COM