Riso CZ180 Series Technical Manual page 204

Thermal Print Head (TPH) over-heat temperature
Sets the temperature reference parameter to judge TPH over-heat. If the machine detects the
TPH temperature to be above this parameter, the machine displays a message and stops the
Description
master-making job.
Turning the machine power OFF and then ON will reset the error message.
0552
Range :
Setting
Unit :
Default :
Thermal Print Head (TPH) over-heat temperature detection Enable or Disable selection.
Description Selection of enabling or disabling the TPH over-heat detection by Test Mode No.0552.
0553
Range :
Setting
Default :
Master return amout after cutter blade disc cuts the master and stops at the cutter-stop-position.
Sets the master return amout after cutter cuts the master and stops at the cutter-stop-position,
Description before the cutter returns to the HP position. (This is to prevent the leading edge of the master
from jamming on the cutter blade disc when the blade returns to the HP position.)
0554
Range :
(+ value returns the master material away from the cutter unit in addition to the standard return
Setting amount programmed.)
Unit :
Default :
Master removal motor speed selection
Description Selects the master-disposal-motor speed in relation to the print drum rotation speed.
Range :
0578
0: Same speed as the print drum speed.
Setting
1: 10% faster than the print drum speed. (default)
2: 20% faster than the print drum speed.
Master disposal box FULL software count Enable or Disable selection.
Description Selection of enabling or disabling the software count FULL detection.
Range :
0585
Setting
Default :
CZ180 / CV1860 Rev. 1.0
RISO Inc. Technical Services & Support
0 to 255 (0 degrees Celcius to 255 degrees Celcius)
(Master compression plate 65° to 100° from HP position).
1 (1 degrees Celcius)
45 (45 degrees Celcius)
0 or 1
0 = Disable 1=Enable
1 (Enable)
-36 to +36 (-3.6mm to +3.6mm)
1 (0.1mm)
0 (0mm)
0 to 2
0 or 1
0 = Disable 1=Enable
1 (Enable)
14 - 11
CHAPTER 14: TEST MODE
US.RISO.COM