Jam Errors (Axx) - Riso CZ180 Series Technical Manual

2) Jam Errors (Axx)

Error Type A01 [Master feed error]
A01-xxx
Description Master Mis-Feed
Pull Out Master Making Unit and Rewind Master Roll, then Reset Master in Place.
To reset Open the master-making unit and rewind the master material on the master roll, and then reset the
display master, or turn OFF the power and power back ON.
Error Point
Master-positioning sensor does not go ON even after the write pulse motor is activated during the
201
master-positioning, master-cut, or master-loading operation.
Master-positioning sensor does not go OFF even when the write pulse motor is reversed during the
202
master-positioning or at start of master-making operation.
211 Master-positioning sensor is ON during standby.
214 Master-positioning sensor is ON at the start of master making.
Even though the Write pulse motor stopped, the pulse count did not match with the programmed
215
pulse count.
Error Type A02 [Master loading error]
A02-xxx
Description Master Loading Error
Pull Out Print Cylinder and Discard Master.
To reset
Pull out the print cylinder and set it back.
display
Error Point
Master-loading sensor was OFF when the master was checked at a specified drum angle during
509
the master-loading operation.
Error Type A04 [Master disposal error]
A04-xxx
Description Master Disposal Error
Pull Out Print Cylinder and Discard Master.
To reset dis-
Pull out the print drum and push it back in.
play
Error Point
303 Check Print Drum - Master removal error / Master disposal jam.
Error Type A05 [Master present in the master disposal area]
A05-xxx
Description Master Jammed in Disposal Unit
Pull Out Master Disposal Box and Remove Jammed Master
To reset dis- Pull out master disposal box and place it back after removing the jammed master in the master
play disposal area, or turn OFF the power and power back ON.
Error Point
304 Master disposal box check request after master removal error or master disposal jam.
312 Master disposal jam sensor was ON at the start of the master making.
CZ180 / CV1860 Rev. 1.0
RISO Inc. Technical Services & Support
CHAPTER 13: PANEL MESSAGE
Error Conditions
Error Conditions
Error Conditions
Error Conditions
13 - 13
US.RISO.COM