Pcb Bracket Open Procedure - Riso CZ180 Series Technical Manual

8. PCB Bracket Open Procedure

1. Turn OFF the machine power and detach the Rear Cover. (M3x8 screws; 5 pcs)
2. Remove the mounting screws (M3x8 screws; 4 pcs) and swing open the PCB Bracket.
Precaution in Assembly:
1) To prevent the wire harness from getting damaged, place the wire harness from the Copy
Counter on top of the Master Counter to prevent the wire harness from dropping onto the wire
harness clamper located on the top portion of the PCB Bracket. Otherwise the Copy Counter
wire harness will be damaged when the PCB Bracket is opened.
Copy Counter Master Counter
2) To prevent the Power Switch Wire Harness from being pinched or cut by the Pressure Spring
when the PCB Bracket is closed, the Power Switch Wire Harness should be placed under the
rear bottom wire harness and main motor relay wire harness when leading the Power Switch Wire
Harness out through the Handle Mounting Bracket-B.
CZ180 / CV1860 Rev. 1.0
RISO Inc. Technical Services & Support
Rear Upper Wire Harness
1 - 19
CHAPTER 1: MAINTENANCE
This is NOT good.
Main Motor Relay Wire Harness
Rear Bottom Wire Harness
Power Switch Wire Harness
Handle Mounting Bracket-B
US.RISO.COM